Apply a thin coat of your paint to all paneling surfaces.
Stripe paint off frooves wall panelling.
Take care of any drips right away too.
Remove any excess paint that collects in the panel grooves using your brush.
Use just enough pressure to take off the paint.
You ll want to use 120 150 grit sandpaper and sand lightly.
You may want to start with a just a piece and work with that especially if you are new to sanding.
To be sure try the steps below on a small area before deciding to remove the paint on the entire wall.
To check sand a small area on the wall.
To fix these paint streaks on walls you ll need to sand down the raised edges.
You can either work with a hand held sander or just a piece of sandpaper.
Sanding too hard can take off the flat paint which would mean another coat application.
Sanding is the number one way to remove paint from wood paneling.
How to paint stripes on your walls.
Paint the paneling in a base color such as white tan or gray.
If the paint is very thick and uneven switch to a 40 grit sanding disk.
If your walls have a vinyl or thin veneer finish you ll need to take extra care when painting them.
Use rotating up and down and sideways motions.
Use a brush to fill in any grooves.
Vinyl coatings come off quickly revealing the pressboard underneath.
Pull off the tape slowly peeling it and folding it back on itself.
Since paneling already has grooves that divide the surface into sections use paint to create a striped effect on the wall.
Apply a thin coat of primer with a roller.
When you re ready to start painting make sure that your paneling is made of solid wood.
If you re lucky the paint will come right off with just a bit of wiping.
For the best finish paint paneling methodically.
When painting for wood paneling choose either a stain blocking latex primer or an oil based primer.
All you need is tape paint and a little creativity.
Begin at the top and work your way down making sure to cover all the gaps between the panels.
Allow the primer to dry a full 24 hours before painting over it.
Some paneling actually consists of a vinyl print that simulates the look of wood.
Tape off the ceiling and trim and cut in paint along the tape creating a border of paint all around the room or the section of wall to be covered.
Do not let the sander linger over any spot as it may gouge the drywall.
Also try not to sand or scrape off the paper surface of the drywall.
Before painting paneling use painter s tape to mask off your mouldings windows doors and ceiling.
Instead you must dissolve the paint and gently scrub it off with a soft bristle brush.
Removing paint from paneling is a delicate process if you want to preserve the paneling because you can t scrape the paint off.
If there are several coats of paint you may want to use a stripper first.
Remove the painter s tape before the paint dries.
